[2016- Mar. -NEW][Braindump2go] Cisco CCNA Data Center 640-916 Study Guide Free Version
2016 March New CCNA Data Center 640-916 DCICT PDF Dumps Update Today!
Refer to the exhibit. Which two pieces of configuration information about interface Ethernet 1/10 can the engineer determine? (Choose two.)
A. It runs at 10 Gbps.
B. It is part of a logical port channel interface.
C. It is configured as a point-to-point interface.
D. It is administratively down.
E. It uses a nonstandard MTU size.
A user is trying to create a new VDC in NX-OS in global configurations mode, but receives an error message. What issue prevents the user from creating Virtual Device Contexts?
A. The user is not granted Super User role permissions.
B. VDCs cannot be created in NX-OS.
C. The user is not a member of VDC Power Admin group.
D. VDCs are not created under interface configurations mode.
Which Cisco Nexus 1000V component provides the platform on which Cisco NX-OS runs and interacts with other components that make up the Cisco Nexus 1000V?
A. Virtual Supervisor Module
B. Virtual Ethernet Module
C. Virtual Service Blade
D. Virtual Security Gateway
What native Fibre Channel technology facilitates connecting multiple Fibre Channel devices behind a single FC address?
A. N-Port Virtualization
B. N-Port Identification Virtualization
C. Fibre Channel Arbitrary Loop
D. Fiber Channel over Ethernet
Refer to the exhibit. An engineer is presented with a VMWare ESX cluster consisting of two VMWare ESX hosts running Nexus 1000v. The guest system inventory consists of 100 static virtual desktops. What change will permit all 100 guests to be online at the same time?
A. increase the global max-ports setting in the Nexus 1000v
B. increase the max-ports setting for the VLAN 10
C. increase the max-ports setting for both VLAN 10 and 20
D. increase the subnet size for VLAN 10 on the 4500x core
E. remove the port channel configuration from the 1000v host uplink port-profile
Which requirement is unique to service profile templates?
C. pooled identities
A network design engineer is asked to design a SAN for a company. Which three underlying principles of SAN design should be considered? (Choose three.)
A. scalability of LAN infrastructure; reduced Ethernet QoS complexity
B. port density and topology requirements; number of ports required now and in the future
C. device performance and oversubscription ratios; determination of what is acceptable and what is unavoidable
D. fault isolation; consolidation while maintaining isolation
E. security management; preferential network security
F. future growth in WAN infrastructure
What data center networking technology is used to converge storage and IP networks within a data center?
2016 640-916 Dumps PDF & 640-916 VCE Files Full Version from Braindump2go: http://www.braindump2go.com/640-916.html 191q Totally!